My 1976 Australian Moke.

YOUR own topic about YOUR own Moke.
Post Reply
User avatar
Martin108
Posts: 129
Joined: Fri Apr 12, 2019 18:45
Location: Northern Ireland

My 1976 Australian Moke.

Post by Martin108 »

New bearings.
18D77466-5029-4EBD-972A-002E3F14E92A.jpeg
You do not have the required permissions to view the files attached to this post.

User avatar
Martin108
Posts: 129
Joined: Fri Apr 12, 2019 18:45
Location: Northern Ireland

My 1976 Australian Moke.

Post by Martin108 »

So tonight I found out what an inner race was. Tried to put the assembled hub onto the radius arm and couldn’t figure out why it would not go right on to the shaft. The inner race from the old bearing was still there. Some heat from my turbo torch, then my hammer and chisel sorted the problem.

1C59D0E1-86F3-4533-9789-ABA102133097.jpeg
0BD84D8D-8F61-44D1-8608-89C8DF82FD28.jpeg
You do not have the required permissions to view the files attached to this post.

User avatar
Martin108
Posts: 129
Joined: Fri Apr 12, 2019 18:45
Location: Northern Ireland

My 1976 Australian Moke.

Post by Martin108 »

This is what I used to remove the inner race. A bit of heat, used the chisel to separate the inner race from the shaft and in a couple of minutes it was off.

B2183E82-04EC-43F7-9FA9-8097703F8D43.jpeg
You do not have the required permissions to view the files attached to this post.

User avatar
Martin108
Posts: 129
Joined: Fri Apr 12, 2019 18:45
Location: Northern Ireland

My 1976 Australian Moke.

Post by Martin108 »

Hub fitted, castle nut, washer and split pin in place. I banged the grease cap too hard and dented it but it’s going to be replaced by an alloy one. Superfin alloy brake drums look good.

3941D0B6-D35C-4D1B-BEB8-CF36A091729A.jpeg
80E66E3F-A68B-431A-876D-63948FB9FE39.jpeg
F099BB9D-1DD5-4F71-985D-C26622DEF980.jpeg
You do not have the required permissions to view the files attached to this post.

User avatar
Martin108
Posts: 129
Joined: Fri Apr 12, 2019 18:45
Location: Northern Ireland

My 1976 Australian Moke.

Post by Martin108 »

One side ready for assembly.

C6D9DE3C-4D67-4E87-857B-9472C3C62867.jpeg
You do not have the required permissions to view the files attached to this post.

Post Reply

Return to “Project "M"”