Plasma cutter

YOUR own topic about YOUR own Moke.
Post Reply
Shaun78
Posts: 58
Joined: Fri May 08, 2020 15:12

Plasma cutter

Post by Shaun78 »

Hi all,I am getting through the bodywork on my restoration been a lot of cutting grinding and welding,then I thought why don't I buy a plasma cutter,so I bought one,got it setup then looked at drivers side floor pan and out in a couple of minutes,got some work to do on hull side but its speeding things up now.can't think why I have never bought one before.so if anyone is doing a restoration a getting fed up with the grinder I would say get a plasma cutter,makes life easier.
wooddypup59
Posts: 17
Joined: Fri Feb 09, 2018 11:28

Re: Plasma cutter

Post by wooddypup59 »

Which make / model did you buy ?
Shaun78
Posts: 58
Joined: Fri May 08, 2020 15:12

Re: Plasma cutter

Post by Shaun78 »

Hi,when I got it I wasn't to sure about them,I found a small retailer by the name of static arc,he had some good reviews so I gave him a go and bought a cutter he had and it has been spot on no problems at all.
Post Reply

Return to “Project "M"”