Maniflow

gizmoke · Post by **gizmoke** » Tue Mar 13, 2007 21:10

Its all fitted with 2 mm to spare between the remote and link pipe.

Post by **Nigel(no top)Sykes** » Tue Mar 13, 2007 21:35

That's until the engine and exhaust start moving around as you drive down the road ...

gizmoke · Post by **gizmoke** » Wed Mar 14, 2007 20:27

Wot with 4 engine steady bars!

Post by **Nigel(no top)Sykes** » Wed Mar 14, 2007 21:33

Just you wait ............ I bet it'll be rattling before the summers out

Post by **Dean** » Sun Mar 18, 2007 1:29

Bob, did you get the same parts I used (did Maniflow still list them)?
There was ample room between the parts on my Moke.
I know you have probably had enough of crawling around under your Moke but, is there any chance of an underside photo of the link pipe and gear selctor box? Use Nigels pit if you can (it's only a few hundred mile drive).
Dean

gizmoke · Post by **gizmoke** » Sun Mar 18, 2007 8:04

I used The CooperFreeflow style. It fitted above the remote bracket so it ran along the side of the linkage.Yes will get some photos today and try to load them!Would use Nigels pit but don't have a deep sea diving lincence.

Post by **Nigel(no top)Sykes** » Mon Mar 19, 2007 21:13

I'll have you know I swept the pit clean today and you're welcome to climb in any time (I might not let you out again though)

Post by **Dean** » Thu Apr 05, 2007 23:11

Photos of Gizmokes exhaust system can be found here http://mokeclub.org/cpg148/thumbnails.php?album=60

Note that this is not the Maniflow system I mentioned in previous posts (and on The Mokelist), photos of which can be found here http://mokeclub.org/cpg148/thumbnails.php?album=59

Dean